6061-O एल्युमिनियम पाना VS 6061-T6 एल्युमिनियम पाना

6061-O र 6061-T6 एल्युमिनियम पाना बीच के भिन्नता छ?

6061-O aluminum sheet and 6061-T6 एल्युमिनियम पाना are two common specifications of aluminum sheets in the 6000 श्रृंखला 6061. तिनीहरूसँग राम्रो गुणहरू छन्. 6061-O र 6061-T6 एल्युमिनियम पानाहरू बीच के भिन्नता छ? 6061-O र 6061-T6 एल्युमिनियम प्लेटहरू बीचको मुख्य भिन्नता तिनीहरूको मेकानिकल गुणहरू हुन्।, especially strength and hardness, which are affected by the tempering process.

6061-O aluminum plate:

रिस: ओ (annealed)

Mechanical behavior:
तन्य शक्ति: Typically approximately 124 MPa (18 ksi)
Yield Strength: Typically approximately 55 MPa (8 ksi)
Elongation: usually around 25%
कठोरता: lower
फॉर्मेबिलिटी: Excellent formability due to its softness. It can be molded, bent, and molded easily without cracking or weakening.

Typical uses:
Typically used in applications where high strength is not a critical requirement but formability and corrosion resistance are critical.
Ideal for applications requiring deep drawing or forming processes such as automotive parts, cans and kitchenware.

6061-T6 aluminum plate:

Condition: टि 6 (solution heat treatment and artificial aging)
Mechanical behavior:
तन्य शक्ति: Typically approximately 310 MPa (45 ksi)
Yield Strength: Typically approximately 275 MPa (40 ksi)
Elongation: usually around 12%
कठोरता: Harder compared to 6061-O due to precipitation hardening process.
फॉर्मेबिलिटी: Although still formable, 6061-T6 is less ductile than 6061-O due to increased strength and hardness. It may require more force to bend or form.

Typical uses:
Structural applications requiring high strength and good corrosion resistance, such as aerospace components, bicycle frames and structural components in construction.
Machined components requiring high strength and excellent machining properties.

Comparison Table:

Property6061-O Aluminum Sheet6061-T6 Aluminum Sheet
तन्य शक्तिTypically around 124 MPa (18 ksi)Typically around 310 MPa (45 ksi)
Yield StrengthTypically around 55 MPa (8 ksi)Typically around 275 MPa (40 ksi)
ElongationTypically around 25%Typically around 12%
कठोरताRelatively lowHigher
फॉर्मेबिलिटीExcellentFormable, but less malleable
Typical UsesDeep drawing, forming processesStructural applications, machined components